- FIREWIRE 800 TO USB 2.0 MAC OS X
- FIREWIRE 800 TO USB 2.0 DRIVERS
- FIREWIRE 800 TO USB 2.0 FULL
- FIREWIRE 800 TO USB 2.0 WINDOWS 8
- FIREWIRE 800 TO USB 2.0 FREE
This is one of the major reasons Firewire 800 host connection isn’t worth the effort under MS Windows. The conclusion was pretty much that the results in the graph shown on the Drobo v2 product page “the Drobo with FireWire 800 and USB 2.0 Performance Charts” may be acheived under some circumstances (such as a completely empty Drobo) but very (most?) often the throughput will be close to the red bars in the picture, not the blue.
FIREWIRE 800 TO USB 2.0 MAC OS X
There was a substantial amount of information about the performance of Drobo v2 Firewire 800 vs USB2 and what Mac OS X users had measured and tested in the old Forum threads which are now gone. If you also happend to have other FW800 device(s) which work better with MS Firewire drivers, well… In my experience the overall average Drobo v2 throughput with USB2.0 is almost as good in Win XP SP3 as FW800 is, and the USB host connection is much more stable and trustworthy.
FIREWIRE 800 TO USB 2.0 DRIVERS
The Unibrain FW800 drivers are OK, but if you have multiple LUNs (as is commonly the case in Win XP since it has the size limitation of 2TB) this doesn’t really work well if you want to be able to disconnect & reconnect the Drobo now and then without rebooting the PC. It’s slightly better, but since it’s at least very hard to get it stable (connection problems and not 100% good behaviour when dis/connecting in Win XP SP3, I cannot recommend anyone to use it on Win XP. In addition, some of the listed capacity is used for formatting and other functions and will not be available for data storage.Assuming a system is properly configured, FireWire 800 should provide the better read/write performance. Your computer’s operating system may use a different standard of measurement and report a lower capacity. Firewire 400 uses a dedicated controller and even though. When referring to drive capacity, one gigabyte, or GB, equals one billion bytes and one terabyte, or TB, equals one thousand billion bytes. USB 2 can reach upto 480mbps, whereas Firewire 400 can only reach 400mbps, however USB 2 can never reach nor sustain its theoretical speed. This value may vary with conditions and product configuration. ▲▲ These measurements have been made under normal conditions, one meter/three feet from the front of the product. Actual data rates may vary depending on operating environment and other factors, such as chosen interface, RAID mode, RAID configuration, and disk capacity. Supports USB data transfer rates of high-speed (480Mbps), full-speed (12Mbps) and low-speed (1. Supports simultaneous operation of multiple USB 2.0 and USB 1.1 devices. Supports FireWire data transfer rate up to 100/200/400/800 Mbps. ▲ These transfer rates were achieved using AJA System Test when connected to a Mac computer via the USB 3.0 interface. Compliant with PCI Express Base Specification 1.0a. *** Hot swapping will result in data loss in a RAID 0 array.
FIREWIRE 800 TO USB 2.0 FULL
To achieve full interface bandwidth, connect the product to a FireWire 800 port on a computer or device. ** By using a FireWire 400 to FireWire 800 adapter cable (sold separately). * To achieve full interface bandwidth, connect the product to a USB 3.0 port on a computer or device.
FIREWIRE 800 TO USB 2.0 FREE
FIREWIRE 800 TO USB 2.0 WINDOWS 8
System monitoring and email alerts for temperature and RAID eventsĪluminum enclosure with heat sink design for 60% better cooling USB 2.0 Hub 12+1 Port with 2.1A iCharge Port Powered with Power Supply.
Power down drives without breaking daisy chain connection 1 x USB 3.0 (UAS compatible and USB 2.0 compatible*)Ģ x FireWire 800 (9-pin) (FireWire 400 compatible**)Ģ x hot-swappable*** 7200 RPM/32MB cache (or greater) hard disks Compatibility list
0 kommentar(er)
